 |
|
|
|
|
Descripton
Gas Piston Parts / Choke Tube Cleaner will allow you to clean these parts in 15 minutes or less.
The time consuming and labor intensive chore of cleaning your gas system
parts and choke tubes is a thing of the past with our Gas Piston Parts /
Choke Tube Cleaner.
SLIP 2000's™ GAS PISTON PARTS / CHOKE TUBE CLEANER was designed with your
health and safety in mind. Unlike other products, this product is
non-flammable, non-hazardous and it is biodegradable. GAS PISTON PARTS /
CHOKE TUBE CLEANER provides you with a safe effective way to clean
carbon and plastic wad fouling from choke tubes and all those Semi
automatic shotguns gas system parts.
Simple to use
For best results, on parts that are not cleaned on regular bases, completely submerse parts to be cleaned and allow to soak for 5 to 15 minutes. Remove parts and wipe, brush or rinse clean. It's
that easy. Depending on the frequency of cleaning or type of ammo used a
second soaking may be required. You may also push a brush or mop lightly
through choke tubes and watch the plastic roll out in sheets.
For larger parts that will not fit into jar, soak a nylon brush or rag
in CTC, apply to area that needs to be cleaned and allow product to set
for 2 to 5 minutes. When ready to clean, saturate brush or rag with CTC
again and wipe or brush away carbon. Parts may also be rinsed clean
under hot water.
After cleaning, always re-apply SLiP2000™ Lubricant to metal surfaces
and allow to penetrate pores of metal. SLiP2000™ will form a barrier and
help keep carbon, lead and plastic from sticking. Your next cleaning
will take half the time.
Other uses
Shotguns - Pistols - Revolvers - Black powder guns - Automatic weapons
May be used in chambers and barrels as a bore cleaner. Apply to cylinder
faces, bolt faces and any other hard to clean areas and allow to soak
for 2 to 10 minutes. Carbon, lead, copper and burnt powder will wipe
clean with a nylon brush. Next cleaning will be much easier with SLIP
2000™ Lubricant/Cleaner. Users will actually be able to wipe carbon and
plastic wad fouling away.
For best results, on parts that are not cleaned on regular bases,
completely submerse parts to be cleaned and allow to soak for 5 to 15
minutes. Remove parts and wipe, brush or rinse clean.
Warning
Gas Piston parts / Choke Tube Cleaner removes all oil protection
from the metal. Make sure parts are completely covered in product if
long term soaking is required. Depending on metal composition makeup,
larger parts that are left partially above water surface and exposed to
the air may rust.
Ordering
To order simply click on the link below or visit the ordering page for more information.
|
|
|
|
